Globe 3850 User Manual download pdf (Page 9)

Page 10

MANUAL SLICER OPERATION

1. With slicer off, pull the food chute completely towards you and place the food product on the food

chute. Slice only boneless, unfrozen product with the slicer. Use the end weight to hold the food

product in place. If the end weight is not needed, it may be stored out of the way by swinging it back

behind the food chute and locking it on the retaining pin.

2. Make sure all knobs are tightened prior to using the slicer.

3. Rotate slice thickness dial counterclockwise to desired slice thickness. After slicing is complete,

always turn slice thickness dial completely clockwise to close slicer table.

4. Turn slicer on by pulling the on/off tab towards you. The power indicator light will illuminate.

DO NOT hold the food product with your hand. Never put you hand on or around food

chute when slicer is on. The food chute handle is the only part of the slicer you should

touch while slicing.

5. Use the food chute handle to manually push the food chute back and forth. The food chute handle

is the only part of the slicer you should touch while slicing. Do not catch slices with your hand. Let

slices drop on paper covered receiving area.

If a product needs to be adjusted during slicing, ALWAYS pull the food chute all the way

towards you. Turn off slicer, and close slicer table prior to adjusting the product and the

end weight.

6. After the last slice stroke, pull the food chute all the way towards you. Turn the slicer off by pushing

the on/off tab inward. The power indicator light will go out. Always turn slice thickness dial

completely clockwise to close the slicer table.

7. Now you can load and unload food product from the food chute.

MANUAL USE OF AUTOMATIC SLICER

ALWAYS make sure the auto engage lever is in the “Manual”

position before turning slicer on (Fig. 10-1).

1. Automatic slicers can be used manually when desired.

2. When manually operating an automatic slicer the auto engage lever

MUST be in the “Manual” position before turning the slicer on. The

lever should not be moved out of the “Manual” position at any time

during use.

3. Turn the slicer on by pressing the start button.

OPERATING INSTRUCTIONS

Figure 10-1

Auto Engage Lever

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

No comments

Globe 3850 User Manual Page 9